Wednesday, December 29, 2010

Attic Insulation

Attic Insulation

Properly insulating and air sealing your attic will help reduce your energy bills. Attics are often one of the easiest places in a house to insulate, especially if you'd like to add insulation.
Before insulating or deciding whether to add insulation to your attic, first see our information about adding insulation to an existing house or selecting insulation for new home construction if you haven't already.
Warning: if you think you have vermiculite insulation in your attic, there's a chance it could contain asbestos. Don't disturb it. Only insulation contractors certified to handle and remove asbestos should deal with vermiculite insulation.


Attic Insulation Techniques

Loose-fill or batt insulation is typically installed in an attic. Although installation costs may vary, loose-fill insulation is usually less expensive to install than batt insulation. When installed properly, loose-fill insulation also usually provides better coverage.
Before installing any type of insulation in your attic, follow these steps:
  • Seal all attic-to-home air leaks. Most insulation does not stop airflow.
    • Duct exhaust fans to the outside. Use a tightly constructed box to cover fan housing on attic side. Seal around the duct where it exits the box. Seal the perimeter of the box to the drywall on attic side.
    • Cover openings—such as dropped ceilings, soffits, and bulkheads—into attic area with plywood and seal to the attic side of the ceiling.
    • Seal around chimney and framing with a high-temperature caulk or furnace cement.
    • At the tops of interior walls, use long-life caulk to seal the smaller gaps and holes. Use expanding foam or strips of rigid foam board insulation for the larger gaps.
  • Install blocking (metal flashing) to maintain fire-safety clearance requirements (usually 3 inches) for heat-producing equipment found in an attic, such as flues, chimneys, exhaust fans, and light housings/fixtures unless the light fixtures are IC (insulation contact) rated. IC-rated lights are airtight and can be covered with insulation.
  • Make sure insulation doesn't block soffit vents to allow for attic ventilation.
  • Check the attic ceiling for water stains or marks. They indicate roof leaks or lack of ventilation. Make repairs before you insulate. Wet insulation is ineffective and can damage your home.
Also insulate and air seal your attic access if it's located in a conditioned part of the house.
You'll want to properly insulate and air seal any knee walls—vertical walls with attic space directly behind them—in your home as well.
Finally, if you're constructing a new home or remodeling, make sure any attic decking, which provides additional storage space or a platform for an HVAC unit or hot water tank, is raised above the ceiling joists to ensure proper insulation depth. The decking then should be installed securely to the top of the raised lumber after the insulation has been installed.

Information from the US Department of Energy

Monday, December 13, 2010

Helping the Process

There's a few things the seller's agent can do that would help the home inspection process along. When the buyer has decided to have a home inspection, the seller should:

1. Make the attic entry accessible. If the entry is in a closet with clothes hanging up, the seller should remove the clothes so when the inspector opens the attic entry, the insulation doesn't come falling down onto the sellers clothes. In most cases the inspector is not allowed to remove the clothes due to insurance restrictions. If there are clothes hanging in the closet, the inspector may not be able to inspect this important area and have to make arrangments to return. Returning may make it necessary for an additional charge. No one wants that.

2. If the electrical panel is hidden behind some storage or shelving, the seller should make this area accessible. Make room to get to the panel. Again, if this important portion of the inspection is not accessible the inspector may have to make a return trip at an additional charge.

3. If there are pets still in the home, most inspectors would appreciate it if these pets are put in a kennel or caged. Even home inspectors don't want to be bitten or just as bad, let the pet outside when they enter the home. If there are cats in the home, we suggest the sellers notify the inspector by leaving a note that there are cats in the home. This way the inspector can look for the cats and be certain the pets aren't accidentally let outside.

4. When there is an alarm on, the seller's agent should let the buyers agent know ahead of time prior to the inspection. Home inspectors don't mind it when there is an alarm, they just do not want to set it off without knowing the code to shut it off.

Monday, December 6, 2010

Winterize your home

So you've pulled your sweaters out of mothballs and found your mittens at the bottom of the coat closet. But what about your house -- is it prepared for the cold months ahead?
You'll be a lot less comfortable in the coming months if you haven't girded Home Sweet Home for Old Man Winter. With the help of several experts, we've boiled down your autumn to-do list to 10 easy tips:

1. Clean those gutters  

Once the leaves fall, remove them and other debris from your home's gutters -- by hand, by scraper or spatula, and finally by a good hose rinse -- so that winter's rain and melting snow can drain. Clogged drains can form ice dams, in which water backs up, freezes and causes water to seep into the house, the Insurance Information Institute says. 
As you're hosing out your gutters, look for leaks and misaligned pipes. Also, make sure the downspouts are carrying water away from the house's foundation, where it could cause flooding or other water damage.
"The rule of thumb is that water should be at least 10 feet away from the house," says Michael Broili, the director of the Well Home Program for the Phinney Neighborhood Association, a nationally recognized neighborhood group in Seattle.

2. Block those leaks
One of the best ways to winterize your home is to simply block obvious leaks around your house, both inside and out, experts say. The average American home has leaks that amount to a nine-square-foot hole in the wall, according to EarthWorks Group.

First, find the leaks: On a breezy day, walk around inside holding a lit incense stick to the most common drafty areas: recessed lighting, window and door frames, electrical outlets.

Then, buy door sweeps to close spaces under exterior doors, and caulk or apply tacky rope caulk to those drafty spots, says Danny Lipford, host of the nationally syndicated TV show "Today's Homeowner." Outlet gaskets can easily be installed in electrical outlets that share a home's outer walls, where cold air often enters.
Outside, seal leaks with weather-resistant caulk. For brick areas, use masonry sealer, which will better stand up to freezing and thawing. "Even if it's a small crack, it's worth sealing up," Lipford says. "It also discourages any insects from entering your home."

3. Insulate yourself

"Another thing that does cost a little money -- but boy, you do get the money back quick -- is adding insulation to the existing insulation in the attic," says Lipford. "Regardless of the climate conditions you live in, in the (U.S.) you need a minimum of 12 inches of insulation in your attic."
Don't clutter your brain with R-values or measuring tape, though. Here's Lipford's rule of thumb on whether you need to add insulation: "If you go into the attic and you can see the ceiling joists you know you don't have enough, because a ceiling joist is at most 10 or 11 inches."
A related tip: If you're layering insulation atop other insulation, don't use the kind that has "kraft face" finish (i.e., a paper backing). It acts as a vapor barrier, Lipford explains, and therefore can cause moisture problems in the insulation.

4. Check the furnace

First, turn your furnace on now, to make sure it's even working, before the coldest weather descends. A strong, odd, short-lasting smell is natural when firing up the furnace in the autumn; simply open windows to dissipate it. But if the smell lasts a long time, shut down the furnace and call a professional.
It's a good idea to have furnaces cleaned and tuned annually. Costs will often run about $100-$125. An inspector should do the following, among other things: Throughout the winter you should change the furnace filters regularly (check them monthly). A dirty filter impedes air flow, reduces efficiency and could even cause a fire in an extreme case. Toss out the dirty fiberglass filters; reusable electrostatic or electronic filters can be washed.

5. Get your ducts in a row

According to the U.S. Department of Energy, a home with central heating can lose up to 60% of its heated air before that air reaches the vents if ductwork is not well-connected and insulated, or if it must travel through unheated spaces. That's a huge amount of wasted money, not to mention a chilly house. (Check out this audit tool for other ideas on how to save on your energy bills this winter.) Ducts aren't always easy to see, but you can often find them exposed in the attic, the basement and crawlspaces. Repair places where pipes are pinched, which impedes flow of heated air to the house, and fix gaps with a metal-backed tape (duct tape actually doesn't stand up to the job over time). Ducts also should be vacuumed once every few years, to clean out the abundant dust, animal hair and other gunk that can gather in them and cause respiratory problems.


6. Face your windows

Now, of course, is the time to take down the window screens and put up storm windows, which provide an extra layer of protection and warmth for the home. Storm windows are particularly helpful if you have old, single-pane glass windows. But if you don't have storm windows, and your windows are leaky or drafty, "They need to be updated to a more efficient window," says Lipford. Of course, windows are pricey. Budget to replace them a few at a time, and in the meantime, buy a window insulator kit, Lipford and Broili recommend. Basically, the kit is plastic sheeting that's affixed to a window’s interior with double-stick tape. A hair dryer is then used to shrink-wrap the sheeting onto the window. (It can be removed in the spring.) "It's temporary and it's not pretty, but it's inexpensive (about $4 a window) and it's extremely effective," says Lipford.

7. Don't forget the chimney

Ideally, spring is the time to think about your chimney, because "chimney sweeps are going crazy right now, as you might have guessed," says Ashley Eldridge, director of education for the Chimney Safety Institute of America. That said, don't put off your chimney needs before using your fireplace, Eldridge advises. "A common myth is that a chimney needs to be swept every year," says Eldridge. Not true. But a chimney should at least be inspected before use each year, he adds. "I've seen tennis balls and ducks in chimneys," he says. Ask for a Level 1 inspection, in which the professional examines the readily accessible portions of the chimney, Eldridge says. "Most certified chimney sweeps include a Level 1 service with a sweep," he adds.
Woodstoves are a different beast, however, cautions Eldridge. They should be swept more than once a year. A general rule of thumb is that a cleaning should be performed for every ¼ inch of creosote, "anywhere that it's found." Why? "If it's ash, then it's primarily lye -- the same stuff that was once used to make soap, and it's very acidic." It can cause mortar and the metal damper to rot, Eldridge says. Another tip: Buy a protective cap for your chimney, with a screen, advises Eldridge. "It's probably the single easiest protection" because it keeps out foreign objects (birds, tennis balls) as well as rain that can mix with the ash and eat away at the fireplace's walls. He advises buying based on durability, not appearance. One other reminder: To keep out cold air, fireplace owners should keep their chimney's damper closed when the fireplace isn't in use. And for the same reason, woodstove owners should have glass doors on their stoves, and keep them closed when the stove isn't in use. Check out CSIA'S Web site for a list of certified chimney sweeps in your area.

8. Reverse that fan

"Reversing your ceiling fan is a small tip that people don't often think of," says Lipford. By reversing its direction from the summer operation, the fan will push warm air downward and force it to recirculate, keeping you more comfortable. (Here's how you know the fan is ready for winter: As you look up, the blades should be turning clockwise, says Lipford.).

9. Wrap those pipes

A burst pipe caused by a winter freeze is a nightmare. Prevent it before Jack Frost sets his grip: Before freezing nights hit, make certain that the water to your hose bibs is shut off inside your house (via a turnoff valve), and that the lines are drained, says Broili. In climes such as Portland, Ore., or Seattle, where freezing nights aren't commonplace, you can install Styrofoam cups with a screw attachment to help insulate spigots, says Broili. Next, go looking for other pipes that aren't insulated, or that pass through unheated spaces -- pipes that run through crawlspaces, basements or garages. Wrap them with pre-molded foam rubber sleeves or fiberglass insulation, available at hardware stores. If you're really worried about a pipe freezing, you can first wrap it with heating tape, which is basically an electrical cord that emits heat.

10. Finally, check those alarms

This is a great time to check the operation -- and change the batteries -- on your home's smoke detectors. Detectors should be replaced every 10 years, fire officials say. Test them -- older ones in particular -- with a small bit of actual smoke, and not just by pressing the "test" button. Check to see that your fire extinguisher is still where it should be, and still works. Also, invest in a carbon-monoxide detector; every home should have at least one.